Croupier

Croupier is a Vanadium demo app of a general card playing game for multiple devices. The app combines Syncbase with Mojo and Flutter and in the near future, will also demonstrate P2P discovery and Syncgroup formation.

Croupier's primary card game is Hearts, but it is only available in single-device form. More games will be added in the future.

In order to run the program, it is recommended to use Android devices. (Support for desktop is deprecated and will be removed soon.)

Prerequisites

Mojo

Currently, development is heavily tied to an existing installation of Mojo. Please ensure that your Mojo checkout is located at $MOJO_DIR and has built out/android_Debug. Instructions are available here.

Dart

Flutter depends on a relatively new version of the Dart SDK. Therefore, please ensure that you have installed the following version or greater:

Dart VM version: 1.13.0-dev.3.1 (Thu Sep 17 10:54:54 2015) on "linux_x64"

If you are unsure what version you are on, use dart --version.

To install Dart, visit their download page. You may need to manually download a specific version of Dart. If so, visit their archives for exact downloads.

Vanadium

A Vanadium installation is expected, since Croupier also depends on the https://github.com/vanadium/mojo.discovery project.

Running Croupier

Credentials

Begin by creating your credentials. These are used to determine who can access your Syncbase instance. Note that running the following command will pop-up the standard principal seekblessings tab in order to obtain your approval to use OAuth.

make creds

Any time you clean the credentials, you will need to obtain fresh credentials.

Note on Multiple Devices

If you have more than 1 device plugged into the computer, you will need to specify which device to use. adb devices will tell you the order of your devices.

It is highly recommended that you mark/remember the order of the devices; it is the same as the order they were plugged into the computer/workstation.

For later devices, instead of ANDROID=1 use 2, 3, 4, etc.

Note: Running Croupier on multiple Android devices simultaneously is still a work-in-progress. The workaround is to launch Croupier on a single device at a time.

Note: This example currently relies on a mount table on the local network at 192.168.86.254:8101. This may be changed to the global mount table at a later time. https://github.com/vanadium/issues/issues/782

Start

Start Croupier on your USB-debugging enabled Android device.

ANDROID=1 make start

Alternatively, use a different integer. Since the first device creates a syncgroup, it is recommended that you wait a short duration before starting up any other devices.

Note: Some devices may limit the number of characters the adb connect command accepts. If this is the case, the app will not launch under make start. One workaround is to delete some non-critical lines in the Makefile, such as --checked and --free-host-ports. See https://github.com/vanadium/issues/issues/831

Deleting Mojo Shell

On your Android device, go to the Apps that you downloaded and Uninstall Mojo Shell from there. This cleanup step is important for when Mojo is in a bad state.

Note: Syncgroup data and some Syncbase data is not cleaned up between runs. This means that deleting Mojo Shell can often be helpful in cases where clearing Mojo Shell's data is insufficient.

Cleaning Up

Due to some issues with mojo_shell, you may occasionally fail to start the program due to a used port. Follow the error's instructions and try again.

Between builds of Mojo and Syncbase, you may wish to clean the app and database info (for rooted devices only) up.

ANDROID=1 make clean

For non-rooted devices, you can manually clear the data of the Mojo Shell app.

You can also clean credentials instead:

ANDROID=1 make clean-creds

Don't forget to do make creds to rebuild them.

Lastly, you can also clear out the pub packages:

make veryclean